Filter
Top Products
22 - 58
22. FA TRANSPARENT FUNCTION
22.6 Personal Computer Side Setting
22.6.7 Accessing the servo amplifier
by the MR Configurator
Make the FA transparent settings with the of MT
Developer.
For details, refer to the following:
22.6.5 Accessing by the MT Developer
22.6.8 Accessing the servo amplifier
by the MR Configurator2
Make the FA transparent settings with the of MT Works2.
For details, refer to the following:
22.6.6 Accessing by the MT Works2
22.6.9 Accessing the inverter by the
FR Configurator
This section explains the setting method of the FA
transparent function of FR Configurator with an example of
connecting to FREQROL A700/F700 series.
(For bus connection)
6. Double-click [GOT] of the PLC side I/F to display
[PLC side I/F Detailed Setting of GOT].
7. Set the IP address and port No. in [Ethernet detail
setting for PC and GOT connection].
Set the IP address and port No. to the same as the
Ethernet download setting.
22.5.1 (b) Ethernet download setting
8. Check either of the followings in [Detail setting for
GOT and PLC connection].
[via GOT(Bus) transparent mode]
Mark the [via GOT(direct coupled) transparent mode]
checkbox.
9. The screen returns to [Transfer Setup]. Click
[Connection Test] to check if GX Developer has been
connected to the Motion controller (Q mode).
Bus connection
Direct CPU connection
1. Click [Settings] [Communication Settings...] in FR
Configurator.