Filter
Top Products
8 - 40
8. ETHERNET CONNECTION
8.4 PLC Side Setting
Ethernet parameter settings of FX3U-ENET-
ADP
(1) Ethernet settings
Set the Ethernet parameter at [FX Parameter] on GX
Works2.
To set FX
3U-ENET-ADP, GX Works2 Ver.1.90U or later
is required.
For details on the setting of FX
3U-ENET-ADP, refer to
the following manual.
FX
3U-ENET-ADP User's Manual
:Required :Set if necessary :Not required
*1 Set a channel according to the installation position of FX
3U-
ENET-ADP on the CPU body.
*2 The default value of IP address is 192.168.1.250. Set the IP
address corresponding to the system configuration.
POINTPOINTPOINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again.
(2) Open settings
POINTPOINTPOINT
When connecting to multiple GOTs and peripheral
devices
The number of protocols equivalent to that of the GOTs
and devices must be set.
\
Item Setting
Setting
(with GOT connected)
Channel
CH1 or CH2
*1
IP Address
192.168.1.250
*2
Open Settings Refer to (2).
Communication Data
Code
(Use default value.)
Disable direct
connection to
MELSOFT
Do not respond to
search for CPU on
network
Item Setting
Setting
(with GOT connected)
Protocol TCP
Open System MELSOFT connection