Filter
Top Products
4 - 18
4. HOW TO MONITOR REDUNTANT SYSTEM
4.3 CC-Link Connection (Intelligent Device Station)
4.3 CC-Link Connection (Intelligent Device Station)
This section describes the CC-Link connection (intelligent device station) that connects the GOT set as the intelligent
device station to the CC-Link network.
The following shows an example of connecting the GOT set as the intelligent device station to the CC-Link network.
(1) Connection method
Connect the CC-Link network system to the GOT.
For details, refer to the following.
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
(2) GT Designer3 setting
Set GT Designer3 as follows.
As the monitoring method, "monitoring by transient transmission" and "monitoring by cyclic transmission" are
available. Each monitor method has advantages and disadvantages.
For details, refer to the following.
3.3 CC-Link System Access Range for Monitoring
Setting item Settings Model
Controller Type MELSEC-QnA/Q/QS, MELDAS C6*
Device setting
(Network setting)
Master station Other (NW No. 0, Station No. 0 (master station))
Q Redundant Setting Do not set the item.
Monitor target
MELSECNET/H remote I/O network
CC-Link connection
Power
supply module
GOT
Network No. 0, Station No. 0
(Master station)
Control
system
(System A)
Empty
Q25PRHCPU
QJ71LP21-25
QJ71BR11
QJ71E71-100
QJ61BT11N
Network No. 0,
Station No. 2
(Intelligent device station)
Empty
Standby system
(System B)
Q25PRHCPU
QJ71LP21-25
QJ71BR11
QJ71E71-100
QJ61BT11N
QJ72LP25-25
QJ71C24N
CC-Link
Network No. 0, Station No. 1
(Standby master station)
Power
supply module
Power
supply module
Empty
Empty