Filter
Top Products
11. CC-Link IE CONTROLLER NETWORK CONNECTION
11.4 PLC Side Setting
11 - 15
9
MELSECNET/H
CONNECTION (PLC
TO PLC NETWORK)
10
MELSECNET/10
CONNECTION (PLC
TO PLC NETWORK)
11
CC-Link IE CONTROLLER
NETWORK
CONNECTION
12
CC-Link IE FIELD
NETWORK
CONNECTION
13
CC-Link CONNECTION
(INTELLIGENT DEVICE
STATION)
14
CC-Link
CONNECTION
(Via G4)
15
INVERTER
CONNECTION
16
SERVO AMPLIFIER
CONNECTION
Parameter settings (Connection to Universal
model QCPU) of System configuration2
(Network Type: Extended mode)
(1) [Network parameter] of GX Works2
(a) Network parameter
: Necessary : As necessary : Not necessary
(2) [Controller Setting] of GT Designer3
POINTPOINTPOINT
(1) Network type of the GOT side
When the network is in the extended mode, be
sure to set the network type of the GOT side to
[CC IE Control extended mode].
For [Controller Setting], of GT Designer3, refer to
the following.
11.3.1 Setting communication interface
(Communication settings)
(2) Network type of the PLC side
Only GX Works2 can set [CC IE Control extended
mode (control station)] or [CC IE Control extended
mode (ordinary station)]. The CPU which is
compatible with the extended mode is Universal
model QCPU only.
Item Set value
Setting necessity
at GOT
connection
Network Type
CC IE Control Ext. Mode
(Control station) (fixed)
Start I/O No.
*1
0000H
Network No.
*2
1
Total Stations 2
Group No. 0 (Fixed)
Station No. 1
Mode
*3
Online
Network Range
Assignment
Same as the following setting
[Network parameter]
of GX Developer
Refresh Parameters
(Use default value)
Interrupt Setting
Interlink transmission
parameters
Routing parameters
Same as the following setting
[Network parameter]
of GX Developer
Item Set value
Network type CC IE Control extended mode
Network No. 1: Network No.1
Station No. 2: Station No.2
Mode Online (auto. reconnection)
Retry 3times (Use default value)
Timeout Time 3sec (Use default value)
Delay Time 1ms (Use default value)
Refresh Interval High (Use default value)
Monitor Speed High (Use default value)