Filter
Top Products
1 - 26
1. PREPARATORY PROCEDURES FOR MONITORING
1.4 Connection Cables for the Respective Connection
1.4 Connection Cables for the Respective Connection
To connect the GOT to a device in the respective connection type, connection cables between the GOT and a device are
necessary.
For cables needed for each connection, refer to each chapter for connection.
1.4.1 GOT connector specifications
The following shows the connector specifications on the GOT side.
Refer to the following table when preparing connection cables by the user.
RS-232 interface
Use the following as the RS-232 interface and RS-232 communication unit connector on the GOT. For the GOT side
connection cable, use a connector and connector cover applicable to the GOT connector.
(1) Connector specifications
*1 For the procedure to check the GT15 hardware version, refer to the GT15 User's Manual.
*2 The terminal block (MC1.5/9-ST-3.5 or corresponding product) of the cable side is packed together with the GT1030, GT1020.
(2) Connector pin arrangement
GOT
Hardware
version
*1
Connector type Connector model Manufacturer
GT16 ―
9-pin D-sub (male)
inch screw fixed type
17LE-23090-27(D4C )
DDK Ltd.
GT1595-X ―
17LE-23090-27(D4CK)
GT1585V-S ―
GT1585-STBA
B or later GM-C9RMDU11 Honda Tsushin Kogyo Co., Ltd.
C
17LE-23090-27(D4CK) DDK Ltd.GT1585-STBD ―
GT1575V-S ―
GT1575-STBA
B or later GM-C9RMDU11 Honda Tsushin Kogyo Co., Ltd.
C
17LE-23090-27(D4CK) DDK Ltd.
GT1575-STBD ―
GT1575-VTBA
D or later GM-C9RMDU11 Honda Tsushin Kogyo Co., Ltd.
E
17LE-23090-27(D4CK)
DDK Ltd.
GT1575-VTBD ―
GT1575-VN ―
GT1572-VN ―
GT1565-V ―
GT1562-VN ―
GT155
―
GT14 ―
GT12 ―
GT115 -Q
―
17LE-23090-27(D3CC)
GT105 -Q
―
GT104 -Q
―
GT1030, GT1020
―
9-pin terminal block
*2
MC1.5/9-G-3.5BK PHOENIX CONTACT Inc
GT15-RS2-9P ―
9-pin D-sub (male)
inch screw fixed type
17LE-23090-27(D3CC) DDK Ltd.
GT01-RS4-M ―
GT16, GT15, GT14, GT12, GT11, GT105 , GT104 , GT01-RS4-M
GT1030, GT1020
9-pin D-sub (male)
GOT main part connecto
r
see from the front
15
69
See from the back of a
GOT main part
9-pin terminal block
SD
RD
ER
DR
SG
CS
RS
NC
NC