Filter
Top Products
22 - 54
22. FA TRANSPARENT FUNCTION
22.6 Personal Computer Side Setting
22.6.5 Accessing by the MT
Developer
This section explains the procedure to set the FA
transparent function of MT Developer with an example of
connecting to motion controller CPU (Q series).
1. Click [Communication] [Communication Setting] in
MT Developer.
2. Check-mark either of the following in [Serial port].
Mark the [RS-232C] checkbox.
Mark the [USB] checkbox.
3. Click [Detail].
When connecting the GOT and PC with serial
When connecting the GOT and PC with USB
4. Check-mark either of the following in [PLC side I/F
setting of PLC module].
[via GOT(Bus) transparent mode]
[via GOT(direct coupled) transparent mode]
5. As necessary, select a CPU that is targeted by using
the transparent function in [CPU].
6. Click [Connection Test].
7. Confirm that the personal computer is connected to
the motion controller CPU (Q series).
Bus connection
Direct CPU connection