2-42
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
12 Server
Make target SPs
available (cont.)
❑
Make sure again that each HBA
sees only the targets (SPs) to
which it is zoned with the following
HP-UX commands:
ioscan -fnC disk
insf -e
❑
Reverify that each HBA sees only
the targets (SPs) to which it is
zoned with the HP-UX following
commands:
ioscan -fnC disk
insf -e
HP-UX documentation
❑
Reverify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
ioscan -fnC disk
❑
Reverify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
❑
ioscan -fnC disk
❑
Checkpoint - Use Navisphere
Manager’s Connectivity Status
dialog box to verify that each HBA
is registered with the storage
system.
Navisphere Manager
administrator’s guide
and online help
13 Server
Configure
PowerPath
devices
❑
Use the following PowerPath
command to configure
PowerPath:
powermt config
❑
Use the following PowerPath
command to configure
PowerPath:
powermt config
PowerPath product
guide
❑
Checkpoint - Use the following
PowerPath command to verify that
PowerPath sees all the paths to
the LUNs:
powermt display dev=all
class=clariion
If PowerPath cannot see all the
paths, verify that
• you registered your PowerPath
license key if you have one
• the OptionsSupported
Autotrespass entry is defined
as described in step 6
• the storage-system properties
are set as defined in step 7 or 8
❑
Checkpoint - Use the following
PowerPath command to verify that
PowerPath sees all the paths to
the LUNs:
powermt display dev=all
class=clariion
If PowerPath cannot see all the
paths, verify that
• you registered your PowerPath
license key if you have one
•the systemtype is defined as
described in step 6
• the storage-system properties
are set as defined in step 7 or 8
Task
With Access Logix Without Access Logix Reference Document