Filter
Top Products
2-50
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
10 Server
Make LUNs
visible
❑
Log in as root and restart the Navisphere Host Agent with the following
HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
CX-Series Server
Software for HP-UX
Installation Guide
❑
Checkpoint - Verify that HP-UX can recognize these LUNs with the
following HP-UX commands:
ioscan -fnC disk
insf -e
If HP-UX does not recognize any LUNs, verify the connection to the
Storage Group.
HP-UX documentation
❑
Checkpoint - Reverify that HP-UX sees device entries for all LUNS with
the following HP-UX command:
ioscan -fnC disk
11 Storage System
Set up Event
Monitor
❑
Plan your monitoring configuration. Navisphere Manager
administrator’s guide
and online help
❑
Use Navisphere Manager to set user options, create templates, and set up
your monitoring configuration.
12 Server
Install the
CLARiiON DMP
driver
❑
Download the CLARiiON DMP driver to the server from Services on the
VERITAS website.
❑
Use the swinstall command to install the CLARiiON DMP driver on the
server.
Note Until rootdg is created (part of vxinstall command) on at least one
disk, DMP displays an error message looking for the config daemon.
VERITAS Volume
Navisphere Manager
documentation
13 Server
Reboot
❑
Reboot the server using the reboot command
• to make LUNs available to the OS
• to make LUNs accessible via both SPs
Important If you do not set the failover mode to 2, you will see only half of the
expected paths to the SPs.
VERITAS Volume
Navisphere Manager
documentation
14 Server
Configure
Volume Manager
❑
Run vxinstall to configure Volume Manager and place at least one LUN
under VxVM control.
VERITAS Volume
Navisphere Manager
documentation
Task
With Access Logix Reference Document