Filter
Top Products
5-34
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Solaris Installation Checklists
5Storage System
Update softwar
e
❑
If currently installed
storage-system software is not at
the required minimum revision,
update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access to
data if they do not have failover
software or if all paths to an SP
are down.
❑
If currently installed
storage-system software is not at
the required minimum revision,
update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access to
data if they do not have failover
software or if all paths to an SP
are down.
Navisphere Manager
administrator’s guide
and online help
For an FC4500 storage system, go to
step 7.
For an FC4500 storage system, go to
step 7.
6 CX300, CX400,
CX500, CX600,
CX700,
or
FC4700-Series
Storage System
Set properties for
PowerPath
For new HBAs
❑
Use the following Navisphere CLI
command to determine the
default storage-system type:
navicli -h
hostname
systemtype
where
hostname
is the IP
address or network name of an
SP in the storage system.
If the default storage-system
system type is
not
3 (CLARiiON
Open), use the following
Navisphere CLI command to set it
to 3:
navicli -h
hostname
systemtype
-config 3
CAUTION The above command
reboots both SPs at the same
time.
For any HBAs
❑
Use the following Navisphere CLI
command to determine the
default storage-system type:
navicli -h
hostname
systemtype
where
hostname
is the IP
address or network name of an
SP in the storage system.
If the default storage-system
system type is
not
3 (CLARiiON
Open), use the following
Navisphere CLI command to set it
to 3:
navicli -h
hostname
systemtype
-config 3
CAUTION The above command
reboots both SPs at the same
time.
Navisphere CLI
reference
Task
With Access Logix Without Access Logix Reference Document