Filter
Top Products
PowerPath Checklist — New NetWare Server and Existing Storage System
4-13
NetWare Installation Checklists
3 Server
Install PowerPath
(cont.)
CAUTION If you use the
server -ns command to bring up
NetWare, you must either load
the PowerPath driver manually or
remove all redundant paths.
Failure to do so may result in LUN
corruption.
CAUTION If you use the
server -ns command to bring up
NetWare, you must either load
the PowerPath driver manually or
remove all redundant paths.
Failure to do so may result in LUN
corruption.
❑
Install any PowerPath patches
from the Software downloads
page on the EMC Powerlink
website:
http://powerlink.emc.com
❑
Install any PowerPath patches
from the Software downloads
page on the EMC Powerlink
website:
http://powerlink.emc.com
PowerPath product
guide
4 Server
Install Host
Agent or Server
Utility
❑
Install the Navisphere Host Agent
or Navisphere Server Utility and
the Navisphere CLI.
❑
Install the Navisphere Host Agent
or Navisphere Server Utility and
the Navisphere CLI.
CX-Series Server
Software for NetWare
Installation Guide
5 Server
Install admsnap
❑
If the server will be a SnapView
production or secondary host,
install the admsnap utility.
N/A
6 Storage System
Update software
❑
If currently installed
storage-system software is not at
the required minimum revision
(see page 4-3), update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access
to data if they do not have failover
software or if all paths to an SP
are down.
❑
If currently installed
storage-system software is not at
the required minimum revision
(see page 4-3), update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access
to data if they do not have failover
software or if all paths to an SP
are down.
Navisphere Manager
administrator’s guide
and online help
Task
With Access Logix Without Access Logix Reference Document