6-8
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Tru64 UNIX Installation Checklist
6 Server
Prepare SRM
Console for Boot LUN
❑
At the SRM console, execute the init command.
Host connectivity guide for Tru64 UNIX
and Tru64 UNIX documentation
❑
Verify that the boot LUN is visible to the console with the
following command:
wwidmgr -show wwid
❑
Execute the following command:
wwidmgr -quickset -udid
udid-num
where
udid-num i
s the UDID number of the boot LUN.
❑
At the SRM console, execute the init command.
❑
Checkpoint — Verify that the boot LUN is visible with
the following command:
show device
7 Server
Install Tru64 UNIX on
boot LUN
❑
Install Tru64 UNIX on the boot LUN.
Host connectivity guide for Tru64 UNIX
and Tru64 UNIX documentation
❑
Apply any required patches and driver updates.
❑
Create an entry in /etc/ddr.dbase to provide support for
CLARiiON LUNs.
❑
Shut down the server.
8Switches
Zone additional paths
❑
Create the rest of the zones between the SPs and the
appropriate HBAs on the server.
Switch management documentation
9 Storage System
Update connection
information
❑
Use Navisphere Manager to disconnect the server from
the Storage Group containing the boot LUN.
Navisphere Manager administrator’s
guide and online help
❑
Use Navisphere Manager to register the remaining
connections for each HBA with the following Initiator
Record properties:
Property Value
Initiator Type Compaq/Tru64
ArrayCommPath Selected
Failover Mode 0
Unit Serial Number Array
❑
Reconnect the server to the Storage Group containing
the boot LUN.
Task
With Access Logix Reference Document