5-42
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Solaris Installation Checklists
13 Server
Configure
PowerPath for
missing devices
❑
Use the following Power Path
commands to configure
PowerPath for any missing logical
devices so all paths to the LUNs
are visible:
powercf -i or powercf -q
powermt config
❑
Use the following PowerPath
commands to configure
PowerPath for any missing logical
devices so all paths to the LUNs
are visible:
powercf -i or powercf -q
powermt config
PowerPath product
guide
❑
Checkpoint - Use the following
PowerPath command to verify
that PowerPath sees all paths to
the LUNs:
powermt display dev=all
class=clariion
If PowerPath cannot see all the
paths, verify that
• You registered your PowerPath
license key.
• The storage-system properties
are set as defined in steps 6 or
7.
❑
Checkpoint - Use the following
PowerPath command to verify
that PowerPath sees all paths to
the LUNs:
powermt display dev=all
class=clariion
If PowerPath cannot see all the
paths, verify that
• You registered your PowerPath
license key.
• The storage-system properties
are set as defined in step 6 or
7.
For an FC4500 storage system
❑
Disconnect the computer from the
serial port on the storage system.
For an FC4500 storage system
❑
Disconnect the computer from the
serial port on the storage system.
Storage-system setup
guide
14 Server
Test PowerPath
with a license
key
If you have a PowerPath license key
Note If your PowerPath license key is
not registered, the load balancing
policy is restricted to basic failover.
❑
Stop all applications accessing
the storage system and disable
user logins to the server.
If you have a PowerPath license key
Note If your PowerPath license key is
not registered, the load balancing
policy is restricted to basic failover.
❑
Stop all applications accessing
the storage system and disable
user logins to the server.
PowerPath product
guide
❑
View the LUNs available to the
server using the following
PowerPath command:
powermt display dev=all
class=clariion
❑
View the LUNs available to the
server using the following
PowerPath command:
powermt display dev=all
class=clariion
❑
Choose one available LUN to
receive I/O for the test.
❑
Choose one available LUN to
receive I/O for the test.
Task
With Access Logix Without Access Logix Reference Document