Filter
Top Products
5-4
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Solaris Installation Checklists
◆ You must have planned your LUNs and RAID Groups, and
Storage Groups if you have Access Logix. Be sure to consider
requirements for SAN Copy, SnapView, MirrorView, and
MirrorView/A if you have this software. The following
documents will help you with this planning:
• EMC CLARiiON CX300, CX500, CX500i, and CX700 Storage
Systems Configuration Planning Guide (P/N 300-001-273)
• EMC CX400-Series and CX600-Series Storage Systems
Configuration Planning Guide (P/N 014003113)
• EMC Fibre Channel Storage System Model FC4700-2
Configuration Planning Guide (P/N 014003087)
• EMC Fibre Channel Storage System Model FC4500, FC5300, and
FC5700 Configuration Planning Guide (P/N 014003039)
Documentation
Each checklist refers to some or all of the documents listed below. We
recommend that you load these documents on your service laptop or,
for an FC4500 or FC4700, on the computer you will connect to the
storage system, before starting the installation.
◆ Documentation that ships with the HBA and HBA driver.
This documentation is also available from the following websites
For Emulex HBAs and drivers:
http://www.emulex.com/ts/docoem/framemc.htm
For QLogic HBAs and drivers:
http://www.qlogic.com/support/drivers_software.asp
and select EMC in the OEM-approved Drivers/Firmware list at the
bottom of the page.
◆ Documentation that ships with the
• Switches and switch management software
• Solaris operating system
◆ Removing ATF or CDE Software Before Installing Other Failover
Software (P/N 069001173)