Filter
Top Products
PowerPath Checklist — Existing Windows Server and New Storage System
7-41
Windows Installation Checklists
14 Storage System
Set Properties for
PowerPath
❑
Use the following Navisphere CLI commands to set the following default
storage-system properties:
navicli -h
hostname
systemtype -config 3
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
where
hostname
is the IP address or network name of an SP in the
storage system.
Navisphere CLI
reference
15 Fibre Channel
Switches
Zone additional
paths
For a Fibre Channel SAN
❑
Zone the Fibre Channel switches to provide a path from each additional
HBA port (host initiator) to the SPs.
Switch management
documentation
❑
If SAN Copy, MirrorView, or MirrorView/A is installed, create any required
zones.
❑
Checkpoint - Use switch management software to verify the switch
connections to the storage system.
16 Server
Make target SPs
available
❑
Restart the Host Agent, then use the Disk Management tool to scan for
disks.
If the disks are not visible, scan for them once more.
Windows documentation
❑
Checkpoint - Use Navisphere Manager’s Connectivity Status dialog box
to verify that each HBA is registered with the storage system.
Navisphere Manager
administrator’s guide
and online help
Task
With Access Logix Reference Document