Filter
Top Products
PowerPath Checklist - New HP-UX Server and Existing Storage System
2-21
HP-UX Installation Checklist
14 Server
Make target SPs
available
❑
Make sure that each HBA sees
only the targets (SPs) to which it
is zoned with the following HP-UX
commands:
ioscan -fnC disk
insf -e
❑
Verify that each HBA sees only
the targets (SPs) to which it is
zoned with the HP-UX following
commands:
ioscan -fnC disk
insf -e
HP-UX documentation
❑
Verify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
ioscan -fnC disk
❑
Verify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
❑
ioscan -fnC disk
❑
Log in as root and restart the
Navisphere Host Agent with the
following HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
❑
Log in as root and restart the
Navisphere Host Agent with the
following HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
CX-Series Server
Software for HP-UX
Installation Guide
❑
Make sure again that each HBA
sees only the targets (SPs) to
which it is zoned with the following
HP-UX commands:
ioscan -fnC disk
insf -e
❑
Reverify that each HBA sees only
the targets (SPs) to which it is
zoned with the HP-UX following
commands:
ioscan -fnC disk
insf -e
HP-UX documentation
❑
Reverify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
ioscan -fnC disk
❑
Reverify that HP-UX sees device
entries for all LUNS with the
following HP-UX command:
❑
ioscan -fnC disk
Task
With Access Logix Without Access Logix Reference Document