6-6
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Tru64 UNIX Installation Checklist
Checklist - New Tru64 UNIX Server and New Storage System With
Boot Disk
This checklist is for a new storage system that will contain a Tru64
UNIX boot disk. If you do not want the new storage system to contain
a boot disk, use the procedure that starts on page 6-4.
Task
With Access Logix Reference Document
1 Server
Install HBAs and
cables
❑
Install the Fibre Channel HBAs. HBA documentation
❑
Connect a cable from each host HBA port to a switch
port.
❑
Checkpoint — Verify the server connections to the
switch by checking the LED(s) for the switch port
connected to each HBA port.
For a 1-Gbit switch - LED is green, which indicates that
the HBA is logged in to the switch port.
For a 2-Gbit switch - One of the following:
• The left LED is green and the right LED is off, which
indicates that a 1-Gbit SP port is logged in to the
switch port.
• For a DS-xxB2 switch, both LEDs are green, which
indicates that a 2-Gbit HBA port is logged in to the
switch port.
• For a DS-xxM2 switch, the left LED is blue and the
right LED is off, which indicates that a 2-Gbit HBA
port is logged in to the switch port.
2 Storage System
Set Base UDID
❑
Set the Base UDID (UUID on screen) for the storage
system.
If necessary, you can determine the available UDID
ranges for the server or cluster with the following
command:
wwidmgr -show wwid
Host connectivity guide for Tru64 UNIX
and Tru64 UNIX documentation