4-24
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
NetWare Installation Checklists
9 Storage System
Cable to switch
or server and
LAN (cont.)
For a 2-Gbit switch - One of the following:
• The left LED is green and the right LED is off, which indicates that a
1-Gbit SP port is logged in to the switch port.
• For a DS-xxB2 switch, both LEDs are green, which indicates that a
2-Gbit HBA port is logged in to the switch port.
• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
which indicates that a 2-Gbit HBA port is logged in to the switch port.
❑
Cable each SP to the LAN connected to the hosts from which you will
manage the storage system.
Storage-system setup
guide.
10 Storage System
Set up security
❑
Use Navisphere Manager to define a global administrator and domain (if
not already defined) and any additional users.
Navisphere security
administrator’s guide
and Navisphere
Manager online help
11 Storage System
Set Properties for
PowerPath
❑
Use the following Navisphere CLI commands to set the following default
storage-system properties:
navicli -h
hostname
systemtype -config 3
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
where
hostname
is the IP address or network name of an SP in the
storage system.
Navisphere CLI
reference
12 Server
Cable additional
HBAs to switches
or storage
system
❑
Cable any additional HBA ports to the switch connected to the storage
system or to SP ports.
Storage-system setup
guide
❑
Checkpoint - For a SAN, verify the HBA connections to the switch by
checking the LED(s) for the switch port connected to each additional HBA
port.
For a 1-Gbit switch - LED is green, which indicates that the HBA port is
logged in to the switch port.
For a 2-Gbit switch - One of the following:
• The left LED is green and the right LED is off, which indicates that a
1-Gbit SP port is logged in to the switch port.
• For a DS-xxB2 switch, both LEDs are green, which indicates that a
2-Gbit HBA port is logged in to the switch port.
• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
which indicates that a 2-Gbit HBA port is logged in to the switch port.
Task
With Access Logix Reference Document