Filter
Top Products
PowerPath Checklist - Existing HP-UX Server and Existing Storage System
2-35
HP-UX Installation Checklist
6Server
Set
storage-system
type (cont.)
For a FC4500 storage system
navicli -d
device
systemtype
-config a
where
device
is the storage system’s
name.
For an FC4500 storage system,
go to step 8.
Navisphere CLI
reference
7
CX300, CX400,
CX500, CX600,
CX700, or
FC4700-Series
Storage System
Set properties for
PowerPath
For a server with registered HBAs
Perform this task
either
• across the LAN connected to the
storage-system SPs
or
• from an attached host or a host
networked to an attached host
or
• from a laptop connected to the
storage system, as described in the
storage-system initialization or
setup guide.
For a server with any HBAs
Perform this task
either
• from an attached host or a host
networked to an attached host
or
• from a laptop connected to the
storage system, as described in the
storage-system initialization or
setup guide.
From the LAN
❑
Use Navisphere Manager’s
Failover Setup Wizard (selected
from the Tools menu on the
toolbar) to set the following
storage-system properties for the
server’s existing HBA ports
(initiators):
Failover mode to 1
Array commpath to Enabled
Navisphere Manager
administrator’s guide
and online help o
Task
With Access Logix Without Access Logix Reference Document