Filter
Top Products
2-10
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
13 Server
Make target SPs
available (cont.)
❑
Log in as root and restart the Navisphere Host Agent with the following
HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
CX-Series Server
Software for HP-UX
Installation Guide
❑
Make sure again that each HBA sees only the targets (SPs) to which it is
zoned with the following HP-UX commands:
ioscan -fnC disk
insf -e
HP-UX documentation
❑
Reverify that HP-UX sees device entries for all LUNS with the following
HP-UX command:
ioscan -fnC disk
14 Storage System
Configure
❑
Use Navisphere Manager to set general storage-system properties. Navisphere Manager
administrator’s guide
and online help
❑
Use Navisphere Manager to create RAID Groups, bind LUNs, create
Storage Groups, and assign LUNs to Storage Groups.
❑
Use Navisphere Manager to connect the server to a Storage Group.
15 Server
Make LUNs visible
❑
Log in as root and restart the Navisphere Host Agent with the following
HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
CX-Series Server
Software for HP-UX
Installation Guide
❑
Checkpoint - Verify that HP-UX can recognize these LUNs with the
following HP-UX commands:
ioscan -fnC disk
insf -e
ioscan -fnC disk
If HP-UX does not recognize any LUNs, verify the connection to the
Storage Group.
HP-UX documentation
16 Storage System
Set up Event
Monitor
❑
Plan your monitoring configuration. Navisphere Manager
administrator’s guide
and online help
❑
Use Navisphere Manager to set user options, create templates, and set up
your monitoring configuration.
Task
With Access Logix Reference Document