Configurations for HP-UX Without EMC Failover Software
2-53
HP-UX Installation Checklist
Configurations for HP-UX Without EMC Failover Software
Read this section if you are installing an HP-UX configuration with a
new server that will not run EMC failover and a new storage system.
A new server and storage system are defined as follows:
New server - A server running HP-UX and not connected to any
storage system.
New storage system - A CX300, CX500, or CX700 storage system that
has the factory default settings and has never been connected to a
server.
Topics relating to the checklist for an HP-UX configuration without
EMC failover software are
◆ Prerequisites ..................................................................................... 2-53
◆ Documentation................................................................................. 2-54
◆ Without EMC Failover Software Checklist - New HP-UX Server
and New Storage System................................................................ 2-55
Prerequisites
◆ All switches must be installed.
◆ Storage systems must be set up, initialized (if required), and
connected to switches, and any optional storage-system software
(Access Logix, SnapView, MirrorView, MirrorView/A) you have
must be installed.
◆ If any storage systems have SnapView, the admsnap utility must
be installed on the servers that will be the SnapView production
and secondary hosts.
◆ If you will use Navisphere Manager 6.X, you must have a host
that is
• Running an operating system that can support the Navisphere
Manager 6.X browser-based client. For an up-to-date list of
such operating systems, refer to the Navisphere Manager 6.X
release notes on http://powerlink.emc.com.
• On a network that is connected to the storage-system servers
and that will be connected to the SPs the storage system.