Filter
Top Products
2-38
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
8 FC4500 Storage
System
Set properties for
PowerPath
(cont.)
From a serially connected laptop
❑
Use the following Navisphere CLI
commands to set the following
storage-system properties for the
server’s existing HBA existing
ports (initiators):
navicli -np -d
device
storagegroup -sethost -host
servername -
failovermode 1
navicli -np -d
device
storagegroup -sethost -host
servername -
arraycommpath 1
where
device
is the name of the
computer port connected to the
storage-system serial port (for
example, com1).
servername
is the name of the
server with the HBAs.
From a serially connected laptop
❑
Use the following Navisphere CLI
commands to set the following
default storage-system properties:
navicli -np -d
device
failovermode 1
navicli -np -d
device
arraycommpath 1
where
device
is the name of the
computer port connected to the
storage-system serial port (for
example, com1).
Storage-system
initialization guide and
Navisphere CLI
reference
For a server with unregistered HBAs
Perform this task
either
• from an attached host or a host
networked to an attached host,
or
• from at a laptop connected to a
storage-system serial port, as
described in the storage-system
setup guide.
From an attached or networked host
❑
Use the following Navisphere CLI
commands to set the following
default storage-system properties:
navicli -d
device
-h
hostname
failovermode 1
navicli -h
hostname
-d
device
arraycommpath 1
where
device
is the storage system’s
name
hostname
is the host’s name or
network address.
Navisphere CLI
reference
Task
With Access Logix Without Access Logix Reference Document