Filter
Top Products
PowerPath Checklist — New Windows Server and Existing Storage System Without Boot Disk
7-19
Windows Installation Checklists
13 CX-Series
or
FC4700-Series
Storage System
Set properties for
PowerPath
❑
Use Navisphere Manager’s
Failover Setup Wizard (selected
from the Tools menu on the
toolbar) to set the following
storage-system properties for the
server’s HBA or NIC ports
(initiators):
Initiator Type to CLARiiON Open
Failover mode to 1
Array commpath to Enabled
Go to step 15.
❑
Use the following Navisphere CLI
command to determine the
default storage-system type:
navicli -h
hostname
systemtype
where
hostname
is the IP
address or network name of an
SP in the storage system.
If the default storage-system
system type is
not
3 (CLARiiON
Open), use the following
Navisphere CLI command to set
it to 3:
navicli -h
hostname
systemtype
-config 3
CAUTION The above command
reboots both SPs at the same
time.
Navisphere Manager
administrator’s guide
and online help or
Navisphere CLI
reference
❑
Use the following Navisphere CLI
commands to set the default
failover mode and array
commpath properties to the
values for PowerPath:
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
where
hostname
is the IP
address or network name of an
SP in the storage system.
Go to step 15.
Navisphere CLI
reference
Task
With Access Logix Without Access Logix Reference Document