Filter
Top Products
PowerPath Checklist — New Windows Server and Existing Storage System With Boot Disk
7-31
Windows Installation Checklists
14 Server
Install PowerPath
❑
Install PowerPath.
❑
Install PowerPath. PowerPath release
notes and PowerPath for
Windows installation
and administrator’s
guide
❑
Reboot the server to complete
the installation of PowerPath.
Contrary to what the PowerPath
documentation states, PowerPath
will not see any logical disks
(LUNs) in the storage system at
this point because the storage
system has not been connected.
❑
Reboot the server to complete
the installation of PowerPath.
Contrary to what the PowerPath
documentation states, PowerPath
will not see any logical disks
(LUNs) in the storage system at
this point because the storage
system has not been connected.
❑
Install any PowerPath patches
from the Software downloads
page on the EMC Powerlink
website:
http://powerlink.emc.com
❑
Install any PowerPath patches
from the Software downloads
page on the EMC Powerlink
website:
http://powerlink.emc.com
15 Fibre Channel
Switches
Zone
additional
paths
❑
Zone the Fibre Channel switches
to provide an additional paths
from the server to each SP.
❑
Zone the FIbre Channel switches
to provide an additional paths
from the server to each SP.
Switch management
documentation
❑
If SAN Copy, MirrorView, or
MirrorView/A is installed, create
any required zones.
❑
Checkpoint - Use switch
management software to verify
the switch connections to the
storage system.
❑
Checkpoint - Use switch
management software to verify
the switch connections to the
storage system
Task
With Access Logix Without Access Logix Reference Document