Filter
Top Products
Checklist - New Tru64 UNIX Server and New Storage System With Boot Disk
6-7
Tru64 UNIX Installation Checklist
3Switches
Zone single path to
SP
❑
Zone the switches to provide a single path from one
HBA (host initiator) to default SP owner of the boot disk
LUN in the storage system.
Do note zone more than one path to the storage system
at this point in the installation procedure. The
installation my fail if both SPs are visible to Tru64 UNIX.
You can zone multiple paths later in the installation
procedure.
Switch management documentation
❑
Checkpoint — Verify that the HBA connection is visible.
If it is not visible, execute the init command at the
server’s console.
Host connectivity guide for Tru64 UNIX
and Tru64 UNIX documentation
4 Storage System
Set connection
properties
❑
Determine the port name and node name of each HBA
connected to the storage system.
Host connectivity guide for Tru64 UNIX
❑
Use Navisphere Manager to register the connection for
each HBA with the following Initiator Record properties:
Property
Value
Initiator Type Compaq/Tru64
ArrayCommPath Selected
Failover Mode 0
Unit Serial Number Array
Navisphere Manager administrator’s
guide and online help
5 Storage System
Bind Boot LUN
CAUTION The RAID Group for the boot LUN must consist of
Fibre Channel disks (
not
ATA disks).
❑
Use Navisphere Manager to create a RAID Group for
the LUN that will be the system disk and bind that LUN.
Navisphere Manager administrator’s
guide and online help
❑
Create a Storage Group for the boot LUN.
❑
After the binding of the boot LUN is completed, use
Navisphere Manager to connect the server to its
Storage Group.
Task
With Access Logix Reference Document