Filter
Top Products
PowerPath Checklist — Existing Solaris Server and Existing Storage System
5-35
Solaris Installation Checklists
6 CX300, CX400,
CX500, CX600,
CX700,
or
FC4700-Series
Storage System
Set properties for
PowerPath (cont.)
❑
Use the following Navisphere CLI
commands to set the following
default storage-system
properties:
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
navicli -h
hostname
unitserialnumber lun (
only
for
server in a Sun Cluster; it
must
left at the default setting for all
other cases)
where
hostname
is the IP
address or network name of an
SP in the storage system.
Go to step 8.
❑
Use the following Navisphere CLI
commands to set the following
default storage-system
properties:
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
navicli -h
hostname
unitserialnumber lun (
only
for
server in a Sun Cluster; it
must
left at the default setting for all
other cases)
where
hostname
is the IP
address or network name of an
SP in the storage system.
Go to step 8.
Navisphere CLI
reference
For existing HBAs
An existing HBA is one that is
registered with the storage system.
❑
Use Navisphere Manager’s
Failover Setup Wizard (selected
from the Tools menu on the
toolbar) to set the following
storage-system properties for the
server’s existing HBA ports
(initiators):
Initiator Type to CLARiiON Open
Failover mode to 1
Array commpath to Enabled
Unit Serial Number to LUN
Go to step 8.
Navisphere Manager
administrator’s guide
and online help
Task
With Access Logix Without Access Logix Reference Document