1-24
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
AIX Installation Checklists
7 Server
Set HBA driver
parameters
❑
Make sure the HBA driver parameters are set to the values required for
CLARiiON and PowerPath.
CAUTION Using improper settings can cause erratic failover behavior,
such as greatly increased I/O delays.
Host connectivity guide
8 Server
Install PowerPath
❑
Insert the PowerPath installation CD and mount it. PowerPath Release
Notes and PowerPath
for UNIX installation and
administrator’s guide
❑
Install PowerPath from the command line or using SMIT.
❑
Register PowerPath.
❑
Install any PowerPath patches from the Software downloads page on the
EMC Powerlink website:
http://powerlink.emc.com
9 Storage System
Install
❑
Install the storage system in the cabinet, if not already installed. Rails and cabinet
documentation
10 Storage System
Initialize and
install software
enablers
❑
Install the Navisphere Initialization Utility on a
non-AIX
host on the
same
subnet
as the storage-system management ports.
Storage-system setup
guide
❑
Use the Navisphere Initialization Utility to initialize the storage system.
❑
If you have SAN Copy, SnapView, and/or MirrorView software, install their
enablers.
Navisphere Manager
administrator’s guide
and online help
11 Storage System
Cable to switch
or server and
LAN
❑
Connect the storage system to the switch or HBA ports. Storage-system setup
guide.
❑
Checkpoint - For a SAN, verify the storage-system connections to the
switch by checking the LED(s) for the switch port connected to each SP
port.
For a 1-Gbit switch - LED is green, which indicates that the SP is logged
in to the switch port.
Switch documentation
For a 2-Gbit switch - One of the following:
• The left LED is green and the right LED is off, which indicates that a
1-Gbit SP port is logged in to the switch port.
• For a DS-xxB2 switch, both LEDs are green, which indicates that a
2-Gbit HBA port is logged in to the switch port.
• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
which indicates that a 2-Gbit HBA port is logged in to the switch port.
❑
Cable each SP to the LAN connected to the hosts from which you will
manage the storage system.
Storage-system setup
guide.
Task
With Access Logix Reference Document