Filter
Top Products
1-36
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
AIX Installation Checklists
11 Server
Cable additional
or replacement
HBAs to switches
or storage
system (cont.)
For a 2-Gbit switch - One of the
following:
• The left LED is green and the
right LED is off, which indicates
that a 1-Gbit SP port is logged
in to the switch port.
• For a DS-xxB2 switch, both
LEDs are green, which
indicates that a 2-Gbit HBA
port is logged in to the switch
port.
• For a DS-xxM2 switch, the left
LED is blue and the right LED
is off, which indicates that a
2-Gbit HBA port is logged in to
the switch port.
For a 2-Gbit switch - One of the
following:
• The left LED is green and the
right LED is off, which indicates
that a 1-Gbit SP port is logged
in to the switch port.
• For a DS-xxB2 switch, both
LEDs are green, which
indicates that a 2-Gbit HBA
port is logged in to the switch
port.
• For a DS-xxM2 switch, the left
LED is blue and the right LED
is off, which indicates that a
2-Gbit HBA port is logged in to
the switch port.
12 Switches
Zone for
additional HBAs
For a SAN
❑
Zone the switches to provide a
path from each additional HBA
port (host initiator) to the
appropriate SPs.
For a SAN
❑
Zone the switches to provide a
path from each additional HBA
port (host initiator) to the
appropriate SPs.
Switch management
documentation
❑
Checkpoint - Use switch
management software to verify
the switch connections to the
storage system.
❑
Checkpoint - Use switch
management software to verify
the switch connections to the
storage system
13 Server
Make target SPs
available
❑
Download the following command
from ftp://ftp.emc.com/pub/elab/
powerpath/aix and execute it:
emc_cfgmgr.sh
❑
Download the following command
from ftp://ftp.emc.com/pub/elab/
powerpath/aix and execute it:
emc_cfgmgr.sh
AIX documentation
❑
Checkpoint - Verify that AIX sees
LUNZ devices with the following
AIX command:
lscfg | grep LUNZ
If AIX does not see LUNZ devices
• Verify that arraycommpath is
set to 1 as described in step 9.
• Execute the following AIX
command:
emc_cfgmgr.sh
❑
Checkpoint - Verify that AIX sees
LUNZ devices with the following
AIX command:
lscfg | grep LUNZ
If AIX does not see LUNZ devices
• Verify that arraycommpath is
set to 1 as described in step 9.
• Execute the following AIX
command:
emc_cfgmgr.sh
Task
With Access Logix Without Access Logix Reference Document