PowerPath Checklist — Existing Solaris Server and Existing Storage System
5-41
Solaris Installation Checklists
11 Server
Make target SPs
available
❑
If you updated the driver or added
additional HBAs, add persistent
bindings to the HBA driver
configuration file.
Note Removing ATF does not
remove or change the persistent
bindings.
❑
If you updated the driver or added
additional HBAs, add persistent
bindings to the HBA driver
configuration file.
Note Removing ATF does not
remove or change the persistent
bindings.
Solaris utilities kit
administrator’s guide
❑
Edit the /kernel/drv/sd.conf file
to add LUNs for the new targets.
❑
Edit the /kernel/drv/sd.conf file
to add LUNs with new targets.
Solaris driver.conf man
page
❑
If you added persistent bindings,
reboot the server using the
reboot - - -r command so the
HBAs can see the targets (SPs).
❑
If you added persistent bindings,
reboot the server using the
reboot - - -r command so the
HBAs can see the targets (SPs).
Solaris documentation
❑
Checkpoint - Use the inquiry
option of the format command to
verify the paths to the storage
system. Alternate paths will have
a device with an ID of
drive type
unknown
.
❑
Checkpoint - Use the inquiry
option of the format command to
verify the paths to the storage
system. Alternate paths will have
a device with an ID of
drive type
unknown
.
12 Server
Make paths to
additional HBAs
available
❑
Use Navisphere Manager to
disconnect and then reconnect
the server and its Storage Group.
N/A Navisphere Manager
administrator’s guide
and online help
❑
Reboot the server using the
reboot - - -r command so the
HBAs can see the LUNs in the
Storage Group.
Task
With Access Logix Without Access Logix Reference Document