Filter
Top Products
2-16
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
6
FC4500
Storage-System
Without Access
Logix
Set
storage-system
type (cont.)
From a serially connected laptop
❑
Use the following Navisphere CLI
command to set the system type
to no auto trespass:
navicli -np -d
device
systemtype
-config a
where
device
is the name of the
computer port connected to the
storage-system serial port (for
example, com1).
Navisphere CLI
reference
7 Storage System
Update software
❑
If currently installed
storage-system software is not at
the required minimum revision
(see page 2-3), update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access to
data if they do not have failover
software or if all paths to an SP
are down.
❑
If currently installed
storage-system software is not at
the required minimum revision
(see page 2-3), update it.
CAUTION During the software
update, hosts connected to the
storage system will lose access to
data if they do not have failover
software or if all paths to an SP
are down.
Navisphere Manager
administrator’s guide
and online help
8Server
Cable to switches
or storage system
❑
Cable the HBA ports to the switch
connected to the storage system
or to SP ports.
❑
Cable the HBA ports to the switch
connected to the storage system
or to SP ports.
Storage-system setup
guide
❑
Checkpoint - For a SAN, verify
the HBA connections to the switch
by checking the LED(s) for the
switch port connected to each
HBA port.
For a 1-Gbit switch - LED is
green, which indicates that the
HBA port is logged in to the switch
port.
❑
Checkpoint - For a SAN, verify
the storage-system connections
to the switch by checking the
LED(s) for the switch port
connected to each HBA port.
For a 1-Gbit switch - LED is
green, which indicates that the
HBA port is logged in to the switch
port.
Task
With Access Logix Without Access Logix Reference Document