2-34
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
HP-UX Installation Checklist
5 Server
Set HBA driver
parameters
❑
Make sure the HBA driver
parameters are set to the values
required for CLARiiON and
PowerPath.
CAUTION Using improper
settings can cause erratic failover
behavior, such as greatly
increased I/O delays.
❑
Make sure the HBA driver
parameters are set to the values
required for CLARiiON and
PowerPath.
CAUTION Using improper
settings can cause erratic failover
behavior, such as greatly
increased I/O delays.
HP-UX Host
connectivity guide and
HBS documentation
6Server
Set
storage-system
type
❑
Edit the Navisphere Host Agent
configuration file agent.config to
comment the OptionsSupported
Autotrespass entry as follows:
# OptionsSupported
Autotrespass
The above entry will set the
initiator type for the HBAs to no
auto trespass when Host Agent is
restarted in the next step.
CX-Series Server
Software for HP-UX
Installation Guide
❑
Log in as root and restart the
Navisphere Host Agent with the
following HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
❑
Log in as root and restart the
Navisphere Host Agent with the
following HP-UX commands:
/sbin/init.d/agent stop
/sbin/init.d/agent start
For an FC4500 storage system, go to
step 8.
❑
From the server, use the following
Navisphere CLI command to set
the system type to no auto
trespass:
For a CX400, CX600, or
FC4700-Series storage system
navicli -h
hostname
systemtype
-config a
where
hostname
is the IP address
or network name of an SP in the
storage system.
Navisphere CLI
reference
Task
With Access Logix Without Access Logix Reference Document