Filter
Top Products
5-10
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Solaris Installation Checklists
9 Storage System
Cable to switch or
server and LAN
❑
Connect the storage system to the switch or HBA ports. Storage-system setup
guide.
❑
Checkpoint - For a SAN, verify the storage-system connections to the
switch by checking the LED(s) for the switch port connected to each SP
port.
For a 1-Gbit switch - LED is green, which indicates that the SP is logged
in to the switch port.
For a 2-Gigabit switch - One of the following:
• The left LED is green and the right LED is off, which indicates that a
1-Gbit SP port is logged in to the switch port.
• For a DS-xxB2 switch, both LEDs are green, which indicates that a
2-Gbit HBA port is logged in to the switch port.
• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
which indicates that a 2-Gbit HBA port is logged in to the switch port.
❑
Cable each SP to the LAN connected to the hosts from which you will
manage the storage system.
10 Storage System
Set up security
❑
Use Navisphere Manager to define a global administrator and domain (if
not already defined) and any additional users.
Navisphere security
administrator’s guide
and Navisphere
Manager online help
11 Storage System
Set Properties
for PowerPath
❑
Use the following the following Navisphere CLI commands to set the
following default storage-system properties to the values for PowerPath:
navicli -h
hostname
systemtype -config 3
navicli -h
hostname
failovermode 1
navicli -h
hostname
arraycommpath 1
navicli -h
hostname
unitserialnumber lun
(only
for server in a Sun
Cluster; it
must
left at the default setting for all other cases)
where
hostname
is the IP address or network name of an SP in the
storage system.
Navisphere CLI
reference
12 Switches
Zone
For a SAN
❑
Zone the switches to provide a path from each HBA port (host initiator) to
the appropriate SPs.
Switch management
documentation
❑
If SAN Copy, MirrorView, or MirrorView/A is installed, create any required
zones.
❑
Checkpoint - Use switch management software to verify the switch
connections to the storage system.
Task
With Access Logix Reference Document