PowerPath Checklist — Existing AIX Server and Existing Storage System
1-37
AIX Installation Checklists
13 Server
Make target SPs
available (cont.)
❑
Checkpoint - Verify that each
HBA sees only the targets (SPs)
to which it is zoned with the
following AIX command:
lsdev -Cc array
❑
Checkpoint - Verify that each
HBA sees only the targets (SPs)
to which it is zoned with the
following AIX command:
lsdev -Cc array
AIX documentation
❑
Restart the Navisphere Host
Agent or run the Navisphere
Server Utility with the following
AIX commands:
Host Agent
/
etc/rc.agent stop
/etc/rc.agent start
Server Utility
/usr/lpp/HOSTUTIL/naviserverutil
❑
Restart the Navisphere Host
Agent or run the Navisphere
Server Utility with the following
AIX commands:
Host Agent
/
etc/rc.agent stop
/etc/rc.agent start
Server Utility
/usr/lpp/HOSTUTIL/naviserverutil
CX-Series Server
Software for AIX
installation guide
❑
Checkpoint - Use Navisphere
Manager’s Connectivity Status
dialog box to verify that each HBA
is registered with the storage
system.
❑
Checkpoint - Use Navisphere
Manager’s Connectivity Status
dialog box to verify that each HBA
is registered with the storage
system.
Navisphere Manager
administrator’s guide
and online help
❑
List the LUNZ devices with the
following AIX command:
lscfg | grep LUNZ
❑
List the LUNZ devices with the
following AIX command:
lscfg | grep LUNZ
AIX documentation
❑
Remove each LUNZ device with
the following AIX command:
rmdev -dl hdisk
n
where
n
is the hdisk number for
the LUNZ device.
❑
Remove each LUNZ device with
the following AIX command:
rmdev -dl hdisk
n
where
n
is the hdisk number for
the LUNZ device.
❑
Execute the following AIX
command:
emc_cfgmg.sh
❑
Execute the following AIX
command:
emc_cfgmg.sh
Task
With Access Logix Without Access Logix Reference Document