Filter
Top Products
4-34
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
NetWare Installation Checklists
9Server
Install PowerPath
❑
Make sure the SCSISAN.CDM
module is not installed.
❑
Make sure the SCSISAN.CDM
module is not installed.
NetWare
documentation
❑
If the Navisphere Host Agent is
running, unload the
Navagent.nlm driver with the
command
unload navagent
❑
If the Navisphere Host Agent is
running, stop it by unloading the
Navagent.nlm driver with the
command
unload navagent
CX-Series Server
Software for NetWare
Installation Guide
❑
Install PowerPath.
❑
Install PowerPath. PowerPath release
notes and PowerPath
for NetWare installation
and administrator’s
guide
Note After PowerPath is installed
on a NetWare 6 server, a device
named
EMC PowerPath Control
Device
appears under
ConsoleOne > Tools > Disk
Management > Devices.This
device is always inactive and is
unavailable for I/O.
Note After PowerPath is installed
on a NetWare 6 server, a device
named
EMC PowerPath Control
Device
appears under
ConsoleOne > Tools > Disk
Management > Devices.This
device is always inactive and is
unavailable for I/O.
CAUTION If you use the
server -ns command to bring up
NetWare, you must either load
the PowerPath driver manually or
remove all redundant paths.
Failure to do so may result in LUN
corruption.
CAUTION If you use the
server -ns command to bring up
NetWare, you must either load the
PowerPath driver manually or
remove all redundant paths.
Failure to do so may result in LUN
corruption.
❑
Install any PowerPath patches
from the Software downloads
page on the EMC Powerlink
website:
http://powerlink.emc.com
❑
Install any PowerPath patches from
the Software downloads page on
the EMC Powerlink website:
http://powerlink.emc.com
Task
With Access Logix Without Access Logix Reference Document