DMP Configurations for Windows
7-57
Windows Installation Checklists
DMP Configurations for Windows
Read this section if you are installing a Windows 2000 VERITAS DMP
configuration with a new server and a new storage system. A new
server and a new storage system are defined as follows:
new server - A server running Windows 2000 and not connected to
any storage system.
new storage system - A CX300, CX500, or CX700 storage system that
has factory default settings and has never been connected to a server.
Topics relating to the checklist for Windows DMP configurations are
◆ Required Host Software Revisions................................................ 7-57
◆ Prerequisites ..................................................................................... 7-58
◆ Documentation................................................................................. 7-59
◆ DMP Checklist — New Windows Server and New Storage
System .............................................................................................. 7-60
Required Host
Software Revisions
This section lists the required software revisions for Windows 2000
configurations.
◆ Windows 2000 operating system revision and any service pack
listed in the EMC Support Matrix on the Powerlink website
(http://powerlink.emc.com)
◆ HBA driver revision listed in the EMC Support Matrix on the
Powerlink website (http://powerlink.emc.com)
◆ VxVM 3.1 for Windows 2000 with HotFix01 or higher
Refer to the EMC Support Matrix and the EMC PowerPath for Windows
administrator’s guide on the Powerlink website
(http://powerlink.emc.com) for the specific revision required for your
Windows 2000 version.