Filter
Top Products
5-28
EMC Installation Roadmap for CX-Series and FC-Series Storage Systems
Solaris Installation Checklists
11 Server
Cable additional
HBAs to switches
or storage system
❑
Cable any additional HBA ports to the switch connected to the storage
system or to SP ports.
Storage-system setup
guide.
❑
Checkpoint - For a SAN, verify the HBA connections to the switch by
checking the LED(s) for the switch port connected to each additional HBA
port.
For a 1-Gbit switch - LED is green, which indicates that the HBA port is
logged in to the switch port.
For a 2-Gigabit switch - One of the following:
• The left LED is green and the right LED is off, which indicates that a
1-Gbit SP port is logged in to the switch port.
• For a DS-xxB2 switch, both LEDs are green, which indicates that a
2-Gbit HBA port is logged in to the switch port.
• For a DS-xxM2 switch, the left LED is blue and the right LED is off,
which indicates that a 2-Gbit HBA port is logged in to the switch port.
12 Switches
Zone additional
HBAs
For a SAN
❑
Zone the switches to provide a path from each additional HBA port (host
initiator) to the SPs.
Switch management
documentation
❑
If SAN Copy, MirrorView, or MIrrorView/A is installed, create any required
zones.
❑
Checkpoint - Use switch management software to verify the switch
connections to the storage system.
13 Server
Make target SPs
available
❑
Add persistent bindings for the new SPs and any new HBAs to the HBA
driver configuration file.
Note Removing ATF does not remove or change the persistent bindings.
Solaris utilities kit
administrator’s guide
❑
Edit the /kernel/drv/sd.conf file to add LUNs and their targets. Solaris driver.conf
man page
❑
Reboot the server using the reboot - - -r command so the HBA can see
the targets (SPs).
Solaris documentation
❑
Checkpoint - Verify that each HBA sees only the targets (SPs) to which it
is zoned.
❑
Checkpoint - Use the inquiry option of the format command to verify that
each path to the storage system has one arraycommpath device with an ID
of
drive type unknown
.
The output of this command should be
Vendor DGC, Product LUNZ
.
Task
With Access Logix Reference Document