DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-185ATM-EI (Expansion Interface Circuit Pack)
9
Figure 9-3. NPE Cross Talk Test #6 schematic
Table 9-79. NPE Crosstalk Test (#6)
Error
Code
Te st
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2 ABORT All DSPs are busy (an unlikely event)
1. Retry the command at 1-minute intervals for a maximum of 3 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due
to TDM-Bus errors.
1. If system has no TDM-Bus errors and is not handling heavy traffic,
repeat test at 1-minute intervals for a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals for a
maximum of 5 times.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2752 ABORT The circuit pack in this location is not an ATM pack.
Continued on next page
ATM
circuit
pack
PNC mode
iodfcrosAWF 040699
DSP
TDM bus
(PN X)
Tone clock
Tone detector
