DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-844EXP-PN (Expansion Port Network)
9
EPN Warm Restart (#956)
The EPN Warm Restart, or EPN Reset Level 1, using the command
reset
port-network P level 1
is used to restart an EPN that has not been taken
out-of-service. It is the least severe of the EPN restart levels and is used in an
attempt to preserve the state of the system as much as possible, thereby
reducing user impact. This restart is attempted on a EPN if it is still in-service, or
as a result of a system technician-demanded EPN Warm Restart.
During an EPN Warm Restart all calls are preserved including voice, data, and
packet calls. Once an event has occurred that requires a warm restart, service is
fully restored within 35 seconds.
Table 9-319. TEST #956 EPN Warm Restart
Error
Code
Tes t
Result Description/ Recommendation
2100 ABORT Could not allocate the necessary system resources to execute this reset.
1. Retry the command at 1-minute intervals for a maximum of 3 times.
1386 ABORT The system link to this EPN is unavailable and cannot be used. This reset
cannot be executed without the link being operational.
1. Refer to SYS-LINK and resolve the link problem.
1387 ABORT This EPN is not in a state where it is possible to perform a Warm Restart on the
EPN. It is necessary to perform an EPN Cold Restart (EPN Reset Level 2)
because of one of the following reasons:
■ The EPN is in an out-of-service state.
■ Insufficient time has elapsed since the last EPN Cold Restart was
performed on this EPN.
2000 ABORT Response to a request made in the internal portion of this reset procedure
was not received within the allowable time period.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals for a maximum of 3 times.
FAIL Internal system error
1. Retry the reset command at 1-minute intervals for a maximum of 3 times.
PASS The EPN Warm Restart procedure completed successfully.
Continued on next page
