DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1376SN-CONF (Switch Node Configuration)
9
i. The SNI is connected to a DS1C, but no DS1C is administered.
To resolve this error, refer to FAIL code 140 for test 759.
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below when
inspecting errors in the system. By clearing error codes associated with the
Configuration Audit
for example, you may also clear errors generated from other
tests in the testing sequence.
Configuration Audit (#759)
This test is non-destructive.
NOTE:
For descriptions of result codes for this test refer to:
■ SNC-BD when the circuit pack tested is a Switch Node Clock (circuit pack
slots 10 or 12).
■ SNI-BD when the circuit pack tested is a Switch Node Interface (circuit
pack slots 2-9 or 13-20).
This test is run via the
test board short
or
test board long
command for SNI
circuit packs or SNC circuit packs.
For SNI circuit packs, this test queries the SNI for SNCs in the same switch node
carrier, SNI peers, DS1Cs, and EI or SNI neighbors that the SNI can
communicate with and compares this data to the administered data.
For SNC circuit packs, this test queries the SNC for SNCs and SNIs in the same
switch node carrier that the SNC can communicate with and compares this data
to the administered data.
Failures of this test cause entries in the error and alarm logs against Switch Node
Configuration (SN-CONF) with the board location of the SNI or SNC.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive, ND = Non-destructive
Configuration Audit (#759) X X ND
Processor Route Audit (#760) X ND
