DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-301status signaling-group
8
The following display shows a typical result when
status signaling-group 1
is
entered.
Level 3
State:
The operational state of the primary and secondary D-channels:
in-service
The D-channel is functioning.
standby
the link is established but the D-channel is not
currently being used for layer 3 signaling.
wait
This is a transitional state in the process of progressing to
the in-service state. The switch has sent an ISDN SERVICE
message requesting establishment of layer 3 communications,
and is awaiting a SERVICE ACKNOWLEDGE message from the
far end to put the D-channel into service.
maintenance busy
The D-channel is no longer in the
multiple-frame-established state at layer 2. When an active
D-channel in a duplex signaling group fails, it is placed into this
state and an interchange to the standby D-channel takes place.
When layer 3 signaling is re-established over the new
D-channel, the failed D-channel is moved from this state to
out-of-service and restarted. If the link is successfully
re-established, it is put into the standby state.
manual-out-of-service
The link carrying the D-channel has
been busied-out by command.
out-of-service
The D-channel is down.
no-link
A link has not been administered for this D-channel on
the signaling-group form.
status signaling-group 1 Page 1 of 1 SPE A
STATUS SIGNALING-GROUP
Group ID: 1
Type: facility associated signaling
Group State: in-service
Primary D-Channel
Link: 1 Port: 01C1924 Level 3 State: in-service
Secondary D-Channel
Link: Port: Level 3 State:
