DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1028MEM-BD (32MB Memory Circuit Pack)
9
Error Log Entries and Test to Clear Values
Notes:
a. This error (3) indicates that a software patch has been applied and either
the software patch is bad or was installed incorrectly.
1. Back out the software patch and run the test memory UUCS long
command to verify that the problem has been cleared.
2. If the PBX system is equipped with High Reliability or Critical
Reliability option (i.e. with duplicated SPEs), and this error occurs, a
SPE interchange will occur if the health of the standby SPE permits
the interchange.
Table 9-405. MEM-BD Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test memory UUCS sh r 1
1 Memory RAM Checksum
Test (#903)
MAJOR OFF test memory UUCS l r 1
3(a) Memory RAM Checksum
Test (#903)
MAJOR
2
2. If a spontaneous interchange has occurred (as indicated by STBY-SPE error type 103 or the
display initcauses screen), and handshake is down, (check with status spe), replace the alarmed
circuit pack on the standby SPE. If handshake is up, execute a test long clear of the alarmed
circuit pack and follow recommended procedures.
OFF test memory UUCS l r 1
101(b) none WNG OFF
150(c) none MAJOR
2
ON test memory UUCS l c
257 Memory Parity Checker
Test (#906)
MINOR ON test memory UUCS sh r 2
513 Any(d) Memory Single Bit Errors
(#902)
MINOR ON test memory UUCS l r 10
769 Memory Multiple Bit
Errors (#902)
MAJOR
2
ON test memory UUCS l r 2
1025 Memory Error
Detection/Correction
Test (#907)
MINOR ON test memory UUCS sh r 1
1281 Memory Burst Read Test
(#908)
MAJOR
2
ON test memory UUCS sh r 1
