DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-973ISDN-TRK (DS1 ISDN Trunk)
9
■ status isdn-testcall
group#/member#
This command displays the progress of the outgoing test call by reporting
bit and block error rates of the tested B-Channel.
■ clear isdn-testcall
group#/member#
This command terminates an outgoing test call already in progress.
Measurements already collected are not cleared until the next test call
begins.
A PASS of the asynchronous test indicates only that the test call was successfully
established. Use the
status
and
list
commands to get the results of the test.
NOTE:
Before attempting to make an ISDN-PRI test call to the public network (that
is, the network is the far-end), make sure that test call service is provisioned
by the network. The user must subscribe to Test Type 108 service and have
the correct far-end test call number administered on the trunk group form
for the call to be allowed.
Table 9-375. TEST #258 ISDN Test Call
Error
Code
Tes t
Result Description/ Recommendation
4 ABORT There is a problem with the Signaling Channel.
1. Consult the procedures for the ISDN-PRI Signaling Group (ISDN-SGRP).
Further information may also be obtained by consulting the procedures for
the ISDN-PRI Signaling Channel (ISDN-LNK).
8 ABORT There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circuit pack
(DS1-BD or UDS1-BD).
1004 ABORT B channel in use.
1. Determine if a call is active on this DS1 ISDN Trunk via the status trunk
group#/member# command.
2. When the service state indicates in-service/idle, retry the test.
1005 ABORT Bad Configuration (such as no Maintenance/Test circuit pack)
1. Make sure the Maintenance/Test Circuit Pack is inserted.
2. Repeat the test.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
Continued on next page
