DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-808EXP-INTF (Expansion Interface Circuit Pack)
9
Expansion Interface Fiber Out-of-Frame (FOOF)
Query Test (#238)
This test is nondestructive. This test is a request to an Expansion Interface circuit
pack to determine if it is currently detecting the framing sequence on the
incoming fiber data stream. If it cannot detect this framing signal, the Expansion
Interface circuit pack will not be able to establish a link with the neighbor
Expansion Interface or Switch Node Interface circuit pack.
Table 9-309. TEST #238 Expansion Interface Fiber Out-of-Frame
Query Test
Error
Code
Tes t
Result Description/ Recommendation
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is not
sufficient data to run test.
1. Issue the list fiber-link command to verify that there is no fiber link
administered to this circuit pack.
2. If there is no fiber administered to this circuit pack, but there should be add
the correct fiber using the add fiber-link command.
3. Retry the command.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 3 times.
FAIL Expansion Interface circuit pack could not detect framing sequence.
1. If the Expansion Interface circuit pack that is failing Test #238 is in the EPN,
and the red LEDs are ON on a large number of circuit packs, then reseat
any Tone-Clock circuit packs in the EPN.
2. Perform the ‘‘Fiber Fault Isolation Procedure’’ in ‘‘Alarms, Errors, and
Troubleshooting’’.
3. Enter display errors and resolve any SNC-BD, TDM-BUS, TDM-CLK, or
SYNC errors.
PASS The Expansion Interface circuit pack has detected the valid framing signal on
the fiber.
1. Refer to errors from other Expansion Interface circuit pack, Switch Node
Interface tests, or DS1 CONV tests (if present) if the link is still not
functioning.
