DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1203PGATE-BD (Packet Gateway Circuit Pack)
9
These errors may be indicative of a circuit pack problem, packet bus problem, or
a problem with another circuit pack on the bus. This test is useful for verifying the
repair of the problem.
This test is non-destructive.
Receive FIFO Overflow Error Counter Test (#596)
The test reads and clears the Receive FIFO Overflow Error Counter on the Packet
Gateway circuit pack. This counter is incremented by the circuit pack when it
detects its packet bus receive buffers overflow.
These errors can occur occasionally due to the statistical sizing of the buffers.
Persistent occurrence of these errors may be indicative of a congested circuit
pack. Distribution of a portion of the traffic load on the circuit pack to other circuit
packs in the system may be necessary.
This test is non-destructive.
Table 9-479. TEST #595 LANBIC Receive Parity Error Counter Test
Error
Code
Tes t
Result Description/ Recommendation
2000 ABORT Response to the test was not received from the circuit pack within the allowable
time period.
1. If the test fails repeatedly, attempt to reset the circuit pack.
2. If the test fails again, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1-10 FAIL The circuit pack is still detecting errors of this type. The error code indicates the
value of the on-board error counter.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, execute the ‘‘Packet Interface Test.’’.
3. If ‘‘Packet Interface Test’’ passes, see repair procedures for Packet Bus.
PASS No errors detected by circuit pack.
