DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1603SYSAM (Circuit Pack)
9
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below when
inspecting errors in the system. By clearing error codes associated with the
SYSAM Reset Test
, for example, you may also clear errors generated from other
tests in the testing sequence.
Notes:
a. If you are invoking the long test sequence from the PPN G3-MT, the
SYSAM Reset Test and SYSAM DPR Test will cause the PPN G3-MT to
logoff and tear down any SYSAM Remote Access connection. After the
test sequence runs, the Error Log should be examined for SYSAM errors
of type 1 and 2049 to determine if either SYSAM Reset Test or SYSAM
DPR Test have failed. If you are invoking the long demand test sequence
from an EPN G3-MT, all tests listed above will run and the results will
display on the EPN G3-MT. The PPN G3-MT will still be logged off and any
SYSAM Remote Access connection will be torn down.
b. These tests can be run only on the active SYSAM circuit pack. If you are
invoking the long test sequence on the standby SYSAM circuit pack, these
tests (Outpulse Relay Test, Analog Looparound Test, and External Modem
Present Test) do not run.
c. This test aborts if an external modem is not administered.
SYSAM Reset Test (#909)
This test is destructive.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive, ND = Non-destructive
SYSAM Reset Test (#909)(a) X X D
SYSAM Dual Port Ram Test (#910)(a) X X D
Sanity Handshake Test (#911) X X ND
Time of Day Clock Test (#913) X X ND
G3-MT Looparound Test (#915) X X ND
Outpulse Relay Test (#916) (b) X X ND
Analog Looparound Test (#917) (b) X X ND
External Modem Present Test (#912) (b)(c) X X ND
