DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1279PKT-INT (Packet Interface Circuit Pack)
9
NO
BOARD
The Packet Interface circuit pack is administered but is not detected as being
physically present.
1. If the Packet Interface circuit pack is present, replace it.
2. If the Packet Interface circuit pack is not physically present, use the
display system-parameters maintenance command to check if the
Packet Interface circuit pack is administered as being present. If it is
administered, use the change system-parameters maintenance
command to change the Packet Interface circuit packs administered to be
those actually present.
NOTE:
If the system is equipped with the High Reliability or Critical Reliability
Configuration, the Packet Interface entry on the system-parameters
maintenance screen will show "y" if translation data is present for a
Packet Interface circuit pack on either the active or standby SPE or if a
Packet Interface circuit pack is present on either the active or standby
SPE. The corresponding entry on the screen can only be changed from
"y" to "n" if a Packet Interface circuit pack is not physically present in the
active SPE. However, if the system is restarted with a restart level equal
or greater than a WARM restart, the Packet Interface circuit pack
maintenance software will automatically detect any Packet Interface
circuit pack physically present on the active or standby SPE and the
corresponding field on the system-parameters maintenance screen will
show a ‘‘y.’’
5001 FAIL The TDM clock on the Processor Port Network has failed.
1. Refer to the “TDM-CLK” to clear this failure.
5002 FAIL The Packet Bus on the Processor Port Network has failed.
1. Refer to “PKT-BUS” to clear this failure.
Table 9-503. TEST #889 Reset Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
