DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-316BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)]
9
Figure 9-14. Path of the BRI Port Local LAN Loop Around
Table 9-140. Test #618 BRI Port Local LAN Loop Around
Error
Code
Te st
Result Description/ Recommendation
1015 ABORT The port is not in the out-of-service state.
1. Display the BRI Port Status form via the status bri-port PCSSpp
command to determine which stations or adjuncts are on this port.
2. Use the extension shown on this form in the status station command to
determine if the station or adjunct is in use.
3. If it is in use, wait until it is idle, and then busyout the port (using the
busyout port PCSSpp command) to place it in the out-of-service state
and repeat this test.
!
WARNING:
Since the ‘‘busyout’’ command is destructive, execution of this
command prior to the port being idle causes all calls associated with
BRI endpoints and all transactions associated with ASAI or Lucent
adjuncts on the port to be torn down. Note that third party calls
established by an ASAI or Lucent adjunct remain connected even
though the port is taken out-of-service.
Continued on next page
BRI LINE
CIRCUIT
PACK
PACKET
INTERFACE
PACKET BUS
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
. . . .
