DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-878FIBER-LK (Fiber Link)
9
a message from software indicating that the failure message was received by
software.
If no failures are detected by the SNI circuit pack, this test will pass.
If this test reports failures, the results screen for the
test fiber-link
command will
show
FAIL
with no FAIL code. The error log must then be displayed via
display
errors
with category PNC to view SNI-BD and FIBER-LK errors and
display
errors
with category PNC-PEER to view SNI-PEER errors.
For EI-EI fiber links, this test is not run. For EI-SNI fiber links, this test is run on the
SNI circuit pack endpoint of the fiber link. For SNI-SNI fiber links, this test is run
on both SNI circuit pack endpoints of the fiber link.
Table 9-335. TEST #777 Failure Audit
Error
Code
Tes t
Result Description/ Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 ABORT The downlink message necessary to run this test could not be sent.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
2302 ABORT The SNI circuit pack claims that it received a bad message from software.
2303 ABORT The SNI circuit pack claims that the test requested by software is invalid.
2304 ABORT SNI firmware is not able to run the test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
Continued on next page
