DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-156ATM-BCH (ATM B-Channel Trunk)
9
Table 9-66. TEST #256 Service State Audit Test
Error
Code
Tes t
Result Description/ Recommendation
1000 ABORT Needed resources not available, port on a call or initializing
1. Run status trunk
grp#
/
mbr#
.
1. Check the results of Test #255.
1018 ABORT Maintenance disabled
1. Enable maintenance by entering y in the Maintenance Tests? field
on page 2 of the change trunk-group form.
1113 ABORT Signaling link failed
1. Run status trunk
grp#
/
mbr#
.
2. Check the results of Test #255.
3. See the ‘‘ATM-SGRP (ATM Signaling Group)’’ maintenance object.
1114 ABORT Signaling link in transitional state
1. Retry the command up to 5 times at 1-minute intervals.
1116 ABORT Trunk not in Out-of-Service/Far-end state and country protocol other than 1
1117 ABORT Service-state audit message outstanding
1. Wait 2 minutes, then try again.
2100 ABORT Could not allocate needed resources
1. Retry the command up to 5 times at 1-minute intervals.
1113 FAIL Signaling link failed
1. See the ‘‘ATM-SGRP (ATM Signaling Group)’’
and ISDN-LNK (ISDN
Signaling Link Port) maintenance objects.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS 1. Wait 4 minutes, then check the Error Log for any new Error Type 3073.
■ If there are none, both sides of the ISDN connection agree on the
service state. The negotiation succeeded.
■ If there is a new 3073 error, then the negotiation failed (the request
timed out).
Continued on next page
