DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-358test signaling-group
8
test signaling-group
test signaling-group group#[short | long] [repeat
#
| clear][schedule]
The test signaling-group validates the administration of a signaling group and
runs a series of diagnostic tests on it.
An ISDN-PRI signaling group is a set of B-channels whose signaling messages
are carried together on a designated D-channel or set of D-channels.
Parameters
test spe-standby
test spe-standby [short | long] [repeat
# | clear][schedule]
This command is valid only on systems with duplicated SPE. The test
spe-standby command performs hardware diagnostic tests on each component
of the standby Switch Processing Element (SPE). This command is also used
with the long option to remove a standby from recent interchange mode. The
sequence begins with testing of the STBY-SPE maintenance object to determine
the availability of the standby SPE. The following tests are run on STBY-SPE:
1. Standby SPE status query
2. Standby SPE handshake test
3. Standby SPE time of day comparison (standby in synch with active)
4. Standby SPE configuration matchup test
The last test is run only in the long sequence. After the above sequence, tests of
each component on the standby SPE are run.
Testing the standby SPE does not affects the availability of the standby SPE for
service only in that execution of the long sequence takes the standby out of
recent interchange mode.
group#
An administered number associated with each signaling group.
