DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-121ANNOUNCE
9
ANNOUNCE
The ANNOUNCE maintenance object logs an error in the hardware error log
when either of the following occurs:
■ A
save announcement
or
restore announcement
command does not
complete successfully.
■ The system fails to restore announcements from tape or disk at boot time.
Hardware Error Log Entries
Notes:
a. Error occurred while saving announcements. See Table 9-49
for an
explanation of aux data and recommended repair actions.
b. Error occurred while saving announcements to the standby SPE. (See the
table in the next section for an explanation of aux data and recommended
repair actions.)
c. User pressed the CANCEL key while announcement was being saved by
the active SPE.
d. User pressed the CANCEL key while announcement was being saved by
the standby SPE.
e. Error occurred while restoring announcements. See Table 9-49
for an
explanation of aux data and recommended repair actions.
f. The PORT field for this error displays which SPE was active when the error
occurred.
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run Full Name of MO
ANNOUNCE none none ANNOUNCEMENT
Table 9-48. ANNOUNCE Error Log Entries
Error Type Aux Data Associated Test
Alarm
Level
On/Off
Board
Test to Clear
Va lue
1(a)(f) any None
257(b)(f) any None
513(c)(f) 0 None
769(d)(f) 0 None
1025(e)(f) any None
